3717-1-04.3(B) / Fixed equipment installation - spacing or sealing.
Observed that the restroom sink was pealing away from the wall. Caulk or otherwise seal the sink to the wall to prevent damage to the plumbing. Observed that the 3 compartment sink was not properly sealed to the wall. Bracket or otherwise seal sink to prevent damage to the plumbing.

3717-1-04(I) / Nonfood-contact surfaces - materials.
Oberserved plywood board used for shelving in the walk in cooler. Stain, paint, or otherwise waterproof wood when it is kept inm areas prone to moisture.

3717-1-05.4(P) / Maintaining refuse areas and enclosures.
Observed some trash build up behind the dumpster. Clean to prevent attracting pests.

3717-1-06.1(C) / Floor and wall junctures - coved, and enclosed or sealed.
Observed that floor and wall junction in the rear room under the 3 comp sink did not have any cove molding. Install cove molding to prevent any damage to the walls while mopping.

3717-1-06.1(A) / Floors, walls, and ceilings.
Repeat Observed a browned ceiling tile above the mop sink in the rear of the facility. Replace or repaint to determine if there is a roof leak that needs to be repaired.

3717-1-06.4(B) / Cleaning - frequency and restrictions.
Observed the area underneath the shelves has a large amount of dust build up. Clean underneath the shelving at a frequency necessary to prevnet dirt build up.