Sampling Details
Sub Type: Other Special Feature: Location:
Area: 3200 Volume (gallons): 137500 Flow measure reading (gpm): Minimum required flow (gpm): 287
Disinfectant: Sodium Hypochlorite Secondary Disinfectant: ORP: Turnover Rate (min):
Total Chlorine (ppm): 5 Free Chlorine (ppm): 5 Combined Chlorine (ppm): 0 Total Bromine (ppm):
Alkalinity (ppm): 80 Pool water temp ˚F: 85 pH: 7.5 Cyanuric acid (ppm):
Spa water temp ˚F: Spa water replaced every 30 days: Max Allow. Filter Flow (gpm): Max Allow. Flow: Jet pump capacity (gpm):
Max Allow. Flow: SF pump capacity (gpm):
[?] A summary of the violations found during the inspection are listed below.

3701-31-04 (B)(4)(a)(vi) / Total alkalinity is tested weekly
Repeat Total alkalinity was not tested weekly.
Test total alkalinity at least once/week.
3701-31-04 (B)(6)(h) / Required meters and gauges maintained/functional
Repeat The flow meter was not functioning.
Maintain all meters and gauges in a properly functioning manner at all times while the pool is in operation.
3701-31-04 (B)(6)(h) / Required meters and gauges maintained/functional
Repeat Required meters and gauges were not maintained or were not functional while the pool is in operation. Sandfilter #3 does not appear to have a functioning pressure gauge.
Maintain all meters and gauges in a properly functioning manner at all times while the pool is in operation.
3701-31-04 (B)(6)(s) / Perimeter barrier is in good repair to prevent unauthorized entry
Repeat Observed a wooden gate located near the snack shack is not self closing and self latching.
Repair the perimeter barrier so that there are not any gaps greater than 4 inches anywhere along the barrier. Recommended to Sue Longo (Assistant Manager) to either permanently lock the gate or ensure the gate is self closing and self latching.


Inspection Information


[?] Facility Type: Pool

[?] Inspection Type: Standard

[?] Inspection Date: 15-August-2016

Comments
1. Pool water was clear
2. Chlorine residual met code requirement.
3. The flow meter was not working, hence couldn't determine the turn over rate.
4. The pressure on the filter was noted at 5 psi.