[?] A summary of the violations found during the inspection are listed below.

No critical violations were documented at the time of inspection.

No violations were documented at the time of inspection.


Inspection Information


Facility Type: Commercial FSO < 25000 sq. ft.

[?] Inspection Type: Follow-up

Inspection Date: 20-January-2016


The following violation(s) have been corrected since the last inspection.
3717-1-02.4(C)(7)/Person in charge: duties - ensure employees are rapidly cooling TCS foods.
The person in charge did not ensure that employees are using proper methods to rapidly cool TCS foods.
To prevent the growth of pathogens, the person in charge shall ensure that employees are using proper methods to rapidly cool TCS foods that are not held hot or are not for consumption within four hours.
3717-1-03.4(D)/Cooling - temperature and time control.
TCS foods were not cooled using the proper time and temperature parameters. Temperature of coney sauce after two hours was 187.
To prevent the growth of pathogens, cooked TCS food shall be rapidly cooled: within two hours from 135°F to 70°F, and within a total of six hours from 135°F to 41°F or less; (2) TCS food shall be cooled within 4 hours to 41˚F or less if prepared from ingredients at ambient temperature, such as reconstituted foods and canned tuna; (3) TCS food received in compliance with laws allowing a temperature above 41˚F during shipment from the supplier, shall be cooled within 4 hours to 41˚F or less; (4) Raw eggs shall be received at 45°F or less and immediately placed in refrigerated equipment that maintains an ambient air temperature of 45°F or less.
3717-1-03.4(E)/Cooling methods - temperature and time control.
Observed improper method for cooling TCS foods.
To prevent the growth of pathogens: (1) Cooling shall be accomplished in accordance with the time and temperature criteria by using one or more of the following methods based on the type of food being cooled: (a) Placing the food in shallow pans; (b) Separating the food into smaller or thinner portions; (c) Using rapid cooling equipment; (d) Stirring the food in a container placed in an ice water bath; (e) Using containers that facilitate heat transfer; (f) Adding ice as an ingredient; or (g) Other effective methods; (2) When placed in cooling or cold holding equipment, food containers in which food is cooling must be arranged so as to provide maximum heat transfer through the container walls and; loosely covered, or uncovered if protected from overhead contamination.
3717-1-04.2(I)/Sanitizing solutions - testing devices.
There is no test kit available for measuring the concentration of the sanitizer. No test strips available for chlorine.
To ensure proper sanitization, a test kit or other device that accurately measures the concentration in PPM (mg/L) of sanitizing solutions shall be provided.
3717-1-04.7(C)/Storage of soiled linens - methods.
Soiled linens were not kept in approved location.
Soiled linens shall be kept in clean, nonabsorbent receptacles or clean, washable laundry bags and stored and transported to prevent contamination of food, clean equipment, clean utensils, and single-service articles or single-use articles.
Comments
Violations have been addressed. Cooling method will be with ice paddles and we discussed proper cleaning and storage of ice paddles, which are considered food contact utensils. Please clean, sanitize, and store wrapped to protect it from contamination.