| 3717-1-04.1(Y) / Temperature measuring devices. Repeat Hot and cold holding equipment thermometer was missing, located incorrectly, or not easily readable. Observed no thermometer in the walk-in cooler or the pizza make line. Ensure a temperature measuring device is located in the warmest portion of both of these units. Correct by reinspection 1/11/2024. REINSPECTION: Observed thermometer in walk-in cooler. Correct by reinspection 1/18/2024 REISNPECTION 2: Observed no change. Correct by 1/25/2024.  |
| 3717-1-04.3(B) / Fixed equipment installation - spacing or sealing. Repeat Fixed equipment not properly sealed or spaced for cleaning. Observed no caulking on the front handwashing sink, rendering the area no longer smooth, durable, non-absorbent, or easily cleanable. Correct by next standard inspection. REINSPECTION 2: PIC stated there is a plan in place for the repair. Correct by next standard inspection. |
| 3717-1-04.5(A)(3) / Cleanliness of nonfood-contact surfaces of equipment. Repeat Non-food contact surfaces of equipment are unclean. Observed fan guards in the walk-in cooler to have excessive dust accumulation. Clean by reinspection 1/11/2024. REINSPECTION: Observed no change. Correct by reinspection 1/18/2024. REINSPECTION 2: Observed no change. Correct by 1/25/2024. |
| 3717-1-05.1(S) / Plumbing system - maintained in good repair. Repeat Plumbing system not properly maintained or repaired. Observed reverse connection of hot and cold water at the and washing sink in the front area. Richland Public Health's Plumbing Department will be in contact. Correct by next standard inspection. REINSPECTION 2: PIC stated there is a plan in place for the repair. Correct by next standard inspection. |
| 3717-1-05.4(O) / Using drain plugs. Repeat No drain plugs in waste receptacle. Observed no drain plug in the dumpster. Contact provider in regards to obtaining required drain plug for dumpster to prohibit potential harborage. Obtain by next standard inspection. REINSPECTION 2: PIC stated there is a plan in place for the repair. Correct by next standard inspection. |
| 3717-1-06.4(A) / Repairing. Repeat Physical facilities not maintained in good repair. Observed holes in the walls throughout the facility, rendering them no longer smooth, durable, non-absorbent, or easily cleanable. Correct by next standard inspection. |
| 3717-1-06.4(A) / Repairing. Repeat Physical facilities not maintained in good repair. Observed the FRP peeling from the wall behind the coat rack in the back room. Correct by next standard inspection. |
| 3717-1-06.4(A) / Repairing. Repeat Physical facilities not maintained in good repair. Observed missing/cracked coving in the following areas: right corner next to registers and behind the coat rack in the back room. Correct by next standard inspection. |
| 3717-1-06.4(A) / Repairing. Repeat Physical facilities not maintained in good repair. Observed broken door latch on the back door. Correct by next standard inspection. |
| 3717-1-06.4(D) / Cleaning ventilation systems, nuisance and discharge prohibition. Repeat Ventilation system not maintained. Observed vents throughout the facility to have excessive dust accumulation. Clean by reinspection 1/11/2024. REINSPECTION: Observed no change. Correct by reinspection 1/18/2024. REINSPECTION 2: Observed vent above prep station to be cleaned. Clean rest of vents by 1/25/2024. |